If you want to avoid the delay caused by miner restart and need to accurately set personalized power values, it is recommended to choose Power Adjustment mode in Remote Control of WhatsMinerTool. This mode will not cause a restart of the miner and only takes a few minutes for the set power to take effect, minimizing interruptions to the greatest extent possible. However, it should be noted that the power setting in this mode will become invalid after the miner restarts and needs to be readjusted. For example, if you want to overclock M63S++and want its overclocked power to reach 9800 W, you can input 9800 directly in normal mode. The miner will take a few minutes to reach the value you set, which means overclocking is successful.

If you can accept the miner restart, it is recommended to choose Performance Mode in Remote Control of WhatsMinerTool. The operation process is simple, just select High, Normal or Low. However, it should be noted that in this mode, such as switching to High performance mode, the power reached at this time is a fixed value, which may not meet your specific power requirements. In addition, implementing overclocking in this way takes some time, about 10-30 minutes.

 If you are not satisfied with the preset power of Performance Mode and need to further adjust the power based on the standard mode, it is recommended to choose Adjust Freq in Remote Control of WhatsMinerTool. This mode is based on the normal performance mode and can accurately adjust the frequency up or down by percentage, but the miner will also restart after the operation.

Summary: All three modes can achieve a purpose of overclocking the miner, but an implementation process is slightly different. You can choose a mode that suits your needs.